SGM-200C Selladora Grado Médico con Cortador / Sello: Largo: 200mm Ancho : 8mm
Instructions:
Adjust the timer according to thickness of the material to be sealed. Use a high-number for thicker material.
In order to enhance the quality of the sealing, perform the
resistance pre-heating. Press the sealer arm twice simulating the
sealing without a package. This procedure may be performed only once
before starting the sealing procedure itself but it should be repeated
every time the equipment goes idle for longer than 1 minute.
Place the envelope on the sealing platform always with the paper
side down(directly on the resistance) and the plastic side up and press
the sealer arm down firmly. The heating time is controlled automatically
after manual adjustment.
When the red LED goes off the sealing will be completed. Slide the
blade to cut the envelope, raise the sealer arm and remove the package.
Note: In order to make the sealing better, wait for 1 or 2 seconds to
release the sealer arm after the red LED goes off. If the heating time
is too long or insufficient the sealing might be inefficient (the
envelope may be stuck to the sealing area when it is pulled or be
visibly badly-sealed). To correct this, adjust the timer properly. Once
adjusted it is not necessary to perform any other adjustment to continue
sealing.
Características:
■ Material: New And High Quality Material
■ Input Voltage : 220V 50/60 Hz
■ Power output: 900W
■ Seal width: 8 mm
■ Seal length: 22~23 cm
■ Dimensions: 363x 98x 150 mm
■ Gross weight: 3.5 kg